Starting point for a SparkMAX ground activation unit

Forum Index › Forums › PowerMAX › Starting point for a SparkMAX ground activation unit

This topic contains 0 replies, has 1 voice, and was last updated by  Chip@JMS 4 years, 9 months ago.

  • Author
    Posts
  • 12/05/2014 at 11:19 am #68

    Chip@JMS
    Participant

    Use the Hobbs switch (connect to manifold vacuum/boost)

    Power up the unit (green LED on)

    Turn switch 1 ON to configure the unit

    Turn switch 4 ON -> 0.75 second voltage ramp in/out

    All other dip switches OFF

    Adjust Output Voltage -> Start at 50% and adjust to clean up your misfires

    Turn off switch 1 to SAVE the configuration

    • This topic was modified 4 years, 2 months ago by  JMS Chip.
  • Author
    Posts

You must be logged in to reply to this topic.