Launch Max for F-150's

Forum Index Forums General Discussion – JMS Launch Max for F-150's

This topic contains 2 replies, has 2 voices, and was last updated by  ecostang 3 years, 3 months ago.

  • Author
    Posts
  • #184

    Chris Hood
    Moderator

    The 11-14 5.0 F-150 Uses the same pins as the 5.0 Mustang per the included instructions. Pin 45=Grey with Orange Tracer; Pin 44=Green with Brown Tracer.

    The 11-14 3.5 Ecoboost F-150 uses the same wire colors but they are at different Pins. Pin 75=Grey with Orange Tracer; Pin 45=Green with Brown Tracer

    The 15-16 5.0 F-150 Uses the same pins as the 15+ Mustang per the instructions too. Pin 73=Grey with Orange Tracer; Pin 74= Green with Brown Tracer.

    The 15-16 3.5 Ecoboost F-150 uses the same wire colors and the same Pins as 11-14. Pin 75=Grey with Orange Tracer; Pin 45= Green with Brown Tracer.

  • #187

    Chris Hood
    Moderator

    After further research I have found that the 2015 and up 3.5 Non-Ecoboost engine in the F-150 has the same pin numbers as the 5.0 F-150 to wire in the LaunchMAX.

    The 2015 and up 2.7 EcoBoost uses the same pins as the 2015-up 3.5 Ecoboost to wire in the LaunchMAX.

    -Charlie

  • #198

    ecostang
    Participant

    I’ve got a 2010 mustang with a 2012 f150 3.5 ecoboost motor and 6r80 trans using the factory PCM and wiring harness. I used the instructions for the f150 and wired up the transbrake. I soldered and shrink wrapped all connections and triple checked the wiring diagrams, the wiring is fairly simple and straight forward. The green led comes on with the key and the red led comes on when ground is applied through the momentary switch.

    The transmission does not hold, with the red light on or off the transmission is unaffected.

    Can anyone help me quick? I’m leaving for the ecoboost battle in 3 days and need this sorted out before I race.

You must be logged in to reply to this topic.